![mashinsky signal tutorial mashinsky signal tutorial](https://i.ytimg.com/vi/kl8nJ4lxyaQ/maxresdefault.jpg)
Most common use is at multi-platform stations (assuming all platforms are equal, i.e.
![mashinsky signal tutorial mashinsky signal tutorial](https://i.imgur.com/67Ya61K.jpg)
While it sounds complicated, it simply means that the signal will "look" down the line at the next signal (or signals if there is a switch and multiple tracks) and if it sees all red, it will be red, if it sees at least one green, it will turn green. If you send more trains than the number of platforms, please see chain signals below.Ī Chain Signal in Realistic View DefinitionĬhain signal will be green if there is at least one green signal behind it.
![mashinsky signal tutorial mashinsky signal tutorial](https://i.ytimg.com/vi/nAWqGf7hEf0/maxresdefault.jpg)
Without the crossing, there wouldn't have to be any signals on such side line. Here such a line crosses a main (double-tracked) line. Single track lines with only one train going back and forth.
![mashinsky signal tutorial mashinsky signal tutorial](https://www.mdpi.com/radiation/radiation-02-00002/article_deploy/html/images/radiation-02-00002-g001.png)
There are basically only two situations where they should be used: To prevent trains from getting stuck nose-to-nose at bi-directional signals, they have to be placed very carefully. They will not block the intersection and the ride will be smooth.įor more examples of intersections, see Junctions page. Trains at both intersections will run correctly. (It is admittedly hard to delete those signals without deleting the whole expensive tunnel though)Īllowing trains to pass in both ways - mostly used in dead end stations with low traffic.Īllowing trains to move only in one direction - often used on double tracks with high traffic. Signals are hard to place in tunnels, but you can get around this by using the multi-signal tool: it will space signals correctly to allow for efficient use of longer tunnels. Signals cannot be placed at station platforms and directly on railway intersections. Each signal costs a small amount of money) Convenient on longer stretches of track! (The tool even lets you change the spacing - if you want a signal every four squares, or five, or eight. There is a multi-signal tool which lets you place several signals evenly spaced out.
Mashinsky signal tutorial manual#
You can change to manual selection as well as one-click one way signals in Game Settings. The game defaults to automatically selecting which type of signal to place, as well as defaulting to two-way signals. Yes, this might at first come across as slightly difficult, but zoom in and you'll soon get the hang of it. You decide which way a one-way signal will orientate by which side of the track you click. two (a second) left mouse button click on the same signal = two way signal will be transformed to one way signal.one (the first) left mouse button click = two way signal will be placed on a railway track.There are currently two kinds of signals: If a block is occupied by a train then the signal dividing these blocks won't allow any other train to enter that occupied block until this block is cleared. Signals prevent trains from crashing into each other while driving on the same track and it is for this reason that they are an important part of any railway system - safety first guys!Ī signal divides a railway line into two sections known as blocks. 4.4 Correct use of bi-directional signals.